The standard cement for acid resistance made from liquid and graded power. Jensil -K is widely used for bonding acid proof tiles, bricks and stones in tanks. tower and floor lining Jensil -K is resisting to all acids in any concentration (except HF acid) solvents and brines. It does not resist alkalies. Jensil -K resists high temperature up to 800º C.

Brick / tile based on Jensil - K is recommended for severe corrosive conditions as in reaction vessels, storage tanks, neutralisation pits, drains, floors and other areas

Jensil - K is used in different industries  like  Chemical Plants, Fertilizers, Dyestuff industries, Textile Mills Explosive material manufactures, Electro-plating plants, Refinery and Battery makers etc.

:

:

:

:

:

PROPERTY

%

°C

This is fast setting silicate cement  based on Sodium and Potassium, Silicate which is used in very strong Acids and high temperatures. It also resists almost al solvents used in Chemical plants.

Jensil -K, Na is available in two components, solution and a power . Both these are mixed at site before use in ratio of 1:3 (Solution to Powder) and gives a very smooth workable mortar which sets in half an hour to a solid hard mass.

It will resist almost all  acids, except Hydrofluoric Acid. It has also poor resistance to water and dilute acids and alkalies.

Great care should be taken in mixing the mortar since it sets very quickly. Only small quantities must be mixed which could be used in15 to 20 minutes. If it starts setting. the mortar will not adhere to the brick surface and will only roll up on it, indicating its uselessness and should be discarded and  another fresh mixing should be made. Allow the brick work to dry for 2 days after  which it should be painted with 20% Hydrochloric Acid.

Kindly consult our Technical service Department for definite recommendations, of course without obligation.

Jensil -K at room temperature , has resistance to wide range of  all concentration acids.  It does not resist Alkalies Jensil-k, Na resists high temperature up to 800°C .

During transport, containers must be protected from contact with other Chemical  and should not be exposed directly to sunlight, Syrup and Powder shall always be kept apart to void exothermic reactin between the two.

Jensil -K, Na  powder and Syrup  should  be kept in a cool and dry place in tightly closed condition, away from moisture, heat and direct sunlight. For safety  reasons, always ensure that  Jensil -K, Na Syrup and Powder are stored away from each other.

Shelf life 

In case if the ambient temp. is more than 30-35 Deg. C, the shelf life of the above materials will get  reduced  accordingly.

Since the odour emanating from the Syrup and from prepared mortar is irritating, it is important that the workplace be provided with adequate ventilation. Contact with skin should be avoided, since  it caused irritation / itching. It is recommended that barrier cream be applied before handling Jensil -K, Na mortar. In case of contact with ski it is washed with soap and plenty of water. If Jensil -K, Na Syrup  splashes in to the aye, eye is washed with plenty of water and medical advices is sought.

Whilst  JENNY CORROSION CONTROLLERS strives to ensure that any advice, information or recommendation given are appropriate and correct, it cannot accept any liability directly or indirectly arising out of the use of the products, since the method and place of application of the product are beyond its control.